Calidris oak veneer and surface treatment

All Calidris wood elements are veneered, with solid edges in oak veneer. Compared with solid wood, oak veneer ensures a more even quality with a finer wood grain pattern and structural continuity, and a stable wooden board that will not warp. Solid wood is a living material that interacts with air humidity and temperature. If solid wood is to be more stable, it must be glued together from many smaller pieces.

We have chosen to use oak, as beautiful oak veneer with clear wood grains and structure. There will be natural variations from tree to tree, and depending on whether the veneer was cut from near the heart of the tree trunk or the bark, and on where the tree grew. Trees draw minerals up from the soil, which form a dark base in what is called the grain structure, so-called mineral streaks, that vary according to where the tree grew. The natural variation is a quality, which is precisely what distinguishes a natural product from industrial imitations in foils, laminates or melamine. It also means that if a product is re-ordered, they may vary in colour, but the differences will be reduced over time through exposure to sunlight.

What is oak veneer?

Oak veneer is thin strips of wood, 0.4 thick, which are glued under pressure on to wood fibre board. The fibreboard is sanded down to 15 mm, so that the finished piece is 16 mm. All Calidris wood originates from sustainable forestry in the EU. 95-98% of the wood comes from Croatia.

The veneer is sorted into different qualities from A to D. Dansani uses only quality A oak veneer for the fronts of front panels and the carcass, and quality B for visible sides on the backs of front panels and inside cabinets.

Quality A consists of:
Primarily quarter-cut oak veneer that is cut at right angles to the grain structure in the wood, to give a uniform linear grain pattern. Fresh knots up to Ø6 mm are acceptable, which means there are no cracks of any kind in the wood. Veneer strips 60-120 mm wide are glued together at the edge.

Quality B consists of:
Mixed quarter-cut and plain-cut, which is cut parallel to the cross section of the wood, which gives more variation and what is referred to as a cathedral pattern. Tight knots up to Ø15 mm are acceptable, which means that there may be a crack, but not a structural break in the oak veneer around the knot. Strips of veneer in differing widths are assembled with a zig-zag glued thread on the back

Quarter cut:

Plain cut:

Colour variations

We supply a very wide range of six different colours in oak veneer, which are all toned from the same raw veneer. It is kept in a dark room to avoid changes caused by sunlight. For each order that is given, the relevant components are sent to our partner, who tones and stains the surfaces to our instructions. This means there is a five-week delivery time, but it ensures that we have control over the raw oak veneer and the final result, and at the same time a wide range in many colours.

We have experimented with many different combinations and stain tones and colours to obtain the fine veneer colours in our palette. Since different tones and stains react differently in connection with the wood, it is impossible to predict the final result of a particular bespoke colour, so we do not offer to do it with oak veneer.

Oak noir

Oak noir

White oak

White oak

Grey oak

Grey oak

Red brown oak

Red brown oak

Light oak

Light oak

Dark oak

Dark oak